Hello Guest it is May 09, 2021, 11:54:35 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dangquan09

Pages: 1
1
General Mach Discussion / Urn manual tool change (Read 102 times)
« on: July 30, 2019, 05:49:57 AM »
im used to an auto changer on a lathe, but if i use a manual dixon type toolpost . what would need to altered so that it goes to a safe place ,chuck stops etc to enable manual change then carry on?
thanks

Pages: 1