Hello Guest it is October 24, 2020, 08:03:12 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - newguitar

Pages: 1
1
Brains Development / Re: Mach3 Plugin
« on: October 12, 2019, 03:55:00 AM »
Reading g code from sd card .

2
General Mach Discussion / When is the Windows 10 Mach3 parallel port driver?
« on: September 25, 2019, 06:03:53 AM »
I formatted the computer.
I installed Windows 10 64 bit.
I installed VMware virtual Windows 7 32 bit and introduced the ports.
That's how I ran the Mach3 software.  :-X

3
Brains Development / Re: Mach3 Plugin
« on: July 11, 2019, 03:06:06 AM »
 :) Thanks

4
Brains Development / Re: Mach3 Plugin
« on: July 10, 2019, 07:34:40 AM »
I programmed my own cnc control card.
I am trying to make my CNC control board compatible with mach3.
Therefore, I must encode the plugin.

5
Brains Development / Mach3 Plugin
« on: July 10, 2019, 06:47:03 AM »
How do I code the Mach3 plugin(dll)  with c # or delphi....?
Is there a source document?

Pages: 1