1
General Mach Discussion / Re: Mach3 freezes constantly_little to no support from.....support.
« on: June 29, 2019, 12:14:52 AM »
Razorweld cut 45 cutter, 99% sure model is TRF-45-6-CC1
Motion controller is whatever came with the Langmuir Crossfire...yes external USB..I could open up the box to see if an actual manufacture name is on the board if needed.
And yes it seems every time I do a "dry run" with plasma cutter off it makes it through the whole cut file. Is there possibly a way to add heavy shielding to the plasma cables or computer cables??
And are you suggesting I go a different route for controller cable like ethernet which would require me to change electronics?
I would even consider the Hypertherm pneumatic if its a fix....I thought I was getting a matched system that was proven to work when Langmuir suggested the Razorweld cut 45.
Thank you for the extensive answers and suggestions...you've given me hope that I just may be able to keep using it.
Motion controller is whatever came with the Langmuir Crossfire...yes external USB..I could open up the box to see if an actual manufacture name is on the board if needed.
And yes it seems every time I do a "dry run" with plasma cutter off it makes it through the whole cut file. Is there possibly a way to add heavy shielding to the plasma cables or computer cables??
And are you suggesting I go a different route for controller cable like ethernet which would require me to change electronics?
I would even consider the Hypertherm pneumatic if its a fix....I thought I was getting a matched system that was proven to work when Langmuir suggested the Razorweld cut 45.
Thank you for the extensive answers and suggestions...you've given me hope that I just may be able to keep using it.