1
General Mach Discussion / 3040 CNC Router (USB) - Struggling with drivers
« on: June 14, 2019, 08:12:49 AM »
I bought the following:
https://www.amazon.co.uk/FORAVER-Machine-300x400mm-Control-Engraving/dp/B07RY7S3RQ/ref=sr_1_3?crid=24QRSWE2ZKWDM&keywords=cnc%2B3040%2B4%2Baxis&qid=1559044873&s=gateway&sprefix=3040%2BCNC%2B4%2Baxis%2Caps%2C164&sr=8-3&th=1
I'm new to this - but my expectations were that everything I received should just work.
Is Mach3 usable via USB with what equipment I have...
I get an error message that says Driver Test failed - and I can't even open the Mach3 software.
Also the emergency start/stop button and spindle adjustment doesn't seem to work. I'm not sure if these are driven by software though. Should I be concerned?
Any help/comments would be appreicated.
Ta
Wayne
https://www.amazon.co.uk/FORAVER-Machine-300x400mm-Control-Engraving/dp/B07RY7S3RQ/ref=sr_1_3?crid=24QRSWE2ZKWDM&keywords=cnc%2B3040%2B4%2Baxis&qid=1559044873&s=gateway&sprefix=3040%2BCNC%2B4%2Baxis%2Caps%2C164&sr=8-3&th=1
I'm new to this - but my expectations were that everything I received should just work.
Is Mach3 usable via USB with what equipment I have...
I get an error message that says Driver Test failed - and I can't even open the Mach3 software.
Also the emergency start/stop button and spindle adjustment doesn't seem to work. I'm not sure if these are driven by software though. Should I be concerned?
Any help/comments would be appreicated.
Ta
Wayne