Messages

1

General Mach Discussion / Motion control

« on: June 13, 2019, 09:56:04 AM »

I have several different messages I need help with. I have a waterjet. everytime I cut the machine either stalls out and says radius to end of arc differs from radius to start. or too slow for pulley using min. At this point I have to completely shut down everything and restart sometimes just to get the machine to jog. Any solutions?

2

General Mach Discussion / Re: too slow for pulley using min

« on: June 13, 2019, 08:44:29 AM »

So when I try to cut a square for example the program will lose its place and then somehow finds it way back? could this be a problem with the motion control?

3

General Mach Discussion / too slow for pulley using min

« on: June 13, 2019, 08:13:32 AM »

I am getting messages that either say RADIUS TO END OF ARC DIFFERS FROM RADIUS TO START. ALSO IT SAYS TOO SLOW FOR PULLEY USING MIN. 
looking for suggestions that may help. I have a Galil motion control. I design on FLEXI and get my G CODE from ENROUTE