1
General Mach Discussion / CNC Masters 1440 lathe to mach3
« on: September 19, 2012, 12:11:03 AM »
Has any one upgraded from the CNC MASTERS MasterXU software to Mach3?
I have seen this discussion started but have not seen any results.
I have not been happy with this cnc masters software.
can save the X off sets yo have to physically move tool to X0.0 and reset to zero every time you start the program etc.
that does not work to well when you have something set up between centers.
Thanks
47mlb
I have seen this discussion started but have not seen any results.
I have not been happy with this cnc masters software.
can save the X off sets yo have to physically move tool to X0.0 and reset to zero every time you start the program etc.
that does not work to well when you have something set up between centers.
Thanks
47mlb