1
General Mach Discussion / Re: TB6560 - Mach3 and laser firing
« on: October 27, 2011, 05:04:57 PM »
Hello again Tweakie.
Well with a bit of help from Marco at LightObject, I was able to get the machine working, firing and doing what its supposed to do.
I reset everything back to ground zero and was able to set pin 7 to pin 14. The output to drive the laser was then picked up from pin 14 on the output card as well as going through the relay being turned on and off my the M3 command as a safety measure.
Although this card does not support engraving, it sure is a cheap solution to replace the Moshidraw card.
Thanks again for your help.
Richard
Well with a bit of help from Marco at LightObject, I was able to get the machine working, firing and doing what its supposed to do.
I reset everything back to ground zero and was able to set pin 7 to pin 14. The output to drive the laser was then picked up from pin 14 on the output card as well as going through the relay being turned on and off my the M3 command as a safety measure.
Although this card does not support engraving, it sure is a cheap solution to replace the Moshidraw card.
Thanks again for your help.
Richard