Messages

1

General Mach Discussion / Re: Mach3 on Windows 7 32 bit - Startup Screen always small

« on: May 04, 2019, 03:48:56 PM »

Yes, I have to grab the bottom of the window to open it since it now opens only half screen.  I'll try that restore and let you know if that resolves it.  Thanks.

2

General Mach Discussion / Re: Mach3 on Windows 7 32 bit - Startup Screen always small

« on: May 03, 2019, 09:28:20 AM »

I restored one of the earliest config files (April 4th) and restarted mach3.. same screen position.  Seems no matter what I do, change and save.. it ALWAYS starts half screen as in my attached picture.  I am getting to the point that something is really faulty and I might have to uninstall and reinstall the whole program.   

3

General Mach Discussion / Re: Mach3 on Windows 7 32 bit - Startup Screen always small

« on: May 03, 2019, 06:10:09 AM »

Hi folks.  Thanks for all the advice and I will try them.  But I should have added in the beginning that I never had an issue with mach3 startup screen until recently.  It always loaded fine on this windows 7 machine.  I can't recall exactly what changed, but I know I didn't mess with the settings.  It done it on its own, or something in windows changed it.  I really shouldn't have to install screensets or anything JUST to get the program to open from the last setting.  It refuses to do that.  It now ALWAYS opens half screen.  An once again, it isn't a show stopper.  I can easily drag open the window.. but it is very annoying.

I'll let you know if I get this resolved.  Thanks.

4

General Mach Discussion / Re: Mach3 on Windows 7 32 bit - Startup Screen always small

« on: May 02, 2019, 10:14:22 AM »

I just hope I have given you the right answer - it's a long while since I had a screen size issue 

Unfortunately that didn't help...     Any other advice or help?

5

General Mach Discussion / Re: Mach3 on Windows 7 32 bit - Startup Screen always small

« on: May 02, 2019, 05:46:14 AM »

Config. / General Config. check Auto Screen Enlarge box.

Tweakie.

I will try that.  Thanks for the fast response Tweakie...

6

General Mach Discussion / Mach3 on Windows 7 32 bit - Startup Screen always small

« on: May 02, 2019, 05:33:02 AM »

Hello.  I am new to mach3, but learning as I go.  My issue is just annoying and I can't figure out how to correct it.  I would like to have the mach3 screen saved as when the last I used it.  Right now, each time I open a new session of mach3, the screen is half the size of what it is suppose to be when I ended the last session.  I took a screen shot of what it looks like when I first startup a session.  I have to expand the mach3 window everytime.  I have tried to re-save the config after I set the screen.  There is also a saved screens in the, I believe, the view... but still that doesn't work.  Can anyone tell me how to save the screen so I don't have to re-size it every time I open a new session?  Thanks.