Hello Guest it is March 28, 2024, 01:34:08 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ricky 2019

Pages: 1 2 3 4 5
1
General Mach Discussion / Re: transposing when routing
« on: July 31, 2019, 07:31:39 PM »
That fixed it.
Thanks

2
General Mach Discussion / Re: transposing when routing
« on: July 31, 2019, 07:17:56 AM »
I did watch the video and I think understand what he was saying, but where are the changes made in Mach 3? I don't think I have come across that portion in mach 3 so I don't think I change that.

3
General Mach Discussion / transposing when routing
« on: July 30, 2019, 10:01:26 PM »
I am new. I have mach 3 with Ethernet smooth stepper and ever thing appears to be right. Down loading trail version of vcarve pro and trying to run the demo sign. It looks good on mach 3 screen but as the router runs it routes the lettering backwards, example is: (Avalon) but routes it like this: nolavA. Its does a very nice job but just backwards. Maybe a setting. I have researched and found very little on it. Has anyone had this issue?

4
General Mach Discussion / Re: Motors stalling /growling
« on: June 09, 2019, 05:41:32 PM »
no it was not. After zeroing it out, it did make one revolution.

5
General Mach Discussion / Re: Motors stalling /growling
« on: June 08, 2019, 11:30:40 AM »
I will have research for a signal generator and a electronic tech.


When entering the G1 xo.1968 f1, it keeps turning never stops and is very slow and rough sounding.

6
General Mach Discussion / Re: Motors stalling /growling
« on: June 07, 2019, 07:07:07 PM »
is there a possible fix for this problem?

7
General Mach Discussion / Re: Motors stalling /growling
« on: June 07, 2019, 05:46:43 PM »
 I do have power supply for each driver, and ESS and BOB.

8
General Mach Discussion / Re: Motors stalling /growling
« on: June 07, 2019, 05:38:56 PM »
Yes I do have a separate power supply for the BOB.

9
General Mach Discussion / Re: Motors stalling /growling
« on: June 06, 2019, 07:02:11 PM »
power from power supply to driver and hope you can hear it.

10
General Mach Discussion / Re: Motors stalling /growling
« on: June 05, 2019, 07:03:31 AM »
I will try to take a video.

Can you tell me exactily were to test for the voltage drop??

Pages: 1 2 3 4 5