Messages

1

Brains Development / Re: Low Spindle Speed limit

« on: April 29, 2019, 01:04:21 AM »

Hi Scott,
I'm new to brains so please forgive my ignorance.  Is there a way to test and only activate the spindle monitoring if you are in auto cycle AND an axis is feeding? Long story short, psiphon if I'm running a program on my lathe, I don't want to feed X or Z if the spindle isn't turning.
Thanks - Franco

Test the spindle RPM, and, if too low, force the program to stop, by sending either a Program Stop or E-Stop button press.