Hello Guest it is March 28, 2024, 03:28:24 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - inkwizitiv

Pages: 1
1
General Mach Discussion / Re: Strange Z zero problem
« on: April 14, 2019, 11:32:24 AM »
That makes no difference

2
General Mach Discussion / Strange Z zero problem
« on: April 09, 2019, 12:31:01 PM »
Can someone please help? When I start a job I zero the tool on the top but when I run it sometimes the Z axis starts + a few millimetres missing the job but when I stop and rewind start again its ok, its as if its reading the Gcode wrong?

Pages: 1