Hello Guest it is March 28, 2024, 09:45:25 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - StevenSeim

Pages: 1
1
Post Processors / Re: Mach 3 Post Processor for MasterCam v8
« on: January 26, 2016, 12:18:59 PM »
Thank you Paul.  I'll load this up and test for myself.

Is the part you intend to cut 2 1/2 or 3D?

2
Post Processors / Mach 3 Post Processor for MasterCam v8
« on: January 15, 2016, 12:38:37 AM »
Hello folks and good day.

I am looking for a MACH 3 (and/or 4) post processor for MasterCam version 8. 

Does such a file exist?  If one does not, is there an existing v8 post process compatible with MACH, say MPFAN?

Please let me know.  Mail me direct at sseim@comcast.net as/if appropriate.

Many thanks!

3
Tutorials / Tutorial files good to go
« on: April 26, 2006, 03:57:52 PM »
Thanks for reposting.

All is well.

Is there a location for suggested controller layouts and diagrams? Does the G-Rex work with the G340, or do the motors connect directly?

If this is a silly question forgive me.  I'm coverting from an even sillier shopbot.

Many thanks.

Steven

4
Tutorials / Re: G-Rex setup guide for new users
« on: April 03, 2006, 04:49:20 PM »
Hello. 

Your .pdf file appears to be corrupted.  I am not able to open it with the v.7 reader. 

Would you mind re-posting?  I'd appreciate it.

I'm in the process of building a new controller based on the G-Rex. 

Many Thanks.

Steven

Pages: 1