Hello Guest it is March 29, 2024, 03:13:14 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - marek2312

Pages: 1
1
General Mach Discussion / Re: mach3 problem steppers wont move
« on: March 12, 2019, 06:32:09 PM »

If jumper 3 is in 2-3 position, you will need to enable pin 14 in Mach3.

correct!!!

Thak You reuelt for help :)


2
General Mach Discussion / mach3 problem steppers wont move
« on: March 07, 2019, 03:24:10 PM »
I have a problem with a machine purchased from eBay
The machine has a built-in driver such as in the picture (jp-3163).

I have a connection with the LPT port because after pressing the emergency button I see the message estop.

The problem is that immediately after turning on mach3, stepper motors stop having a holding moment.

After rebooting before turning on mach3, everything returns to normal.
Have you ever had a similar problem?

Pages: 1