Messages

1

General Mach Discussion / Warp9 ESS communicates will not give output signal, m3 crashes on poit config. S

« on: February 25, 2019, 10:49:11 PM »

I have purchased a license through NFS and installed everything via warp9. The LED indicated PC communication, top green solid bottom blinking, top red off bottom functions with software e stop. Db25 BOB and Ebay driver. Axis moves on mach 3 nothing outputs on motor or Bob with voltmeter. Video uploading to YouTube. Funny thing is lots of freeze and crash going out of any port configuration screen and motor config. The estop screen pops up and clicking ok to clear dialog freezes it up and have to end program. Need help. Table is ready

Chuck 906 420 3874
YouTube - Northern Racing Fabrication
https://youtu.be/61L0RSlc_wM