1
Mach4 General Discussion / Re: Mach4 does not recognize inputs from Galil I/O controller
« on: April 15, 2019, 02:14:59 PM »
Hi, we ran a Cat5 cable to a switch and then 2 separate Cat5 cables to the DMC and RIO. The RIO has a built in switch, so you could run a single cable to it and then from there to the DMC. We didn't do that because we put the RIO in the head unit and DMC in the control cabinet (Biesse Rover 336) and didn't want to run another Cat5 cable to the head.
As far as I know, the Galil suite can only address one controller at a time, so either the DMC or RIO. You select which one and then can fire outputs, look at inputs, etc.
-Eric
As far as I know, the Galil suite can only address one controller at a time, so either the DMC or RIO. You select which one and then can fire outputs, look at inputs, etc.
-Eric