Messages

1

General Mach Discussion / Re: Reboot whenever I open Mach3????

« on: February 10, 2019, 01:22:06 PM »

Hi Everyone. I have a fresh installation of Windows 7 Ultimate, 32 bit. The computer has MS Office 360 and Mach3 installed. It runs fine unless I open Mach3. If I open Mach3 it instantly reboots. I read elsewhere that there were compatibility issues with KB4088875; it is not installed. The hot processor/corrupt drive scenarios discussed elsewhere seem unlikely because the system runs fine for days and then reboots if I try to open Mach3. Any suggestions or guidance would be appreciated.

my issue has been solved!!!

2

Share Your GCode / raster pictures??????

« on: February 10, 2019, 12:57:42 PM »

Im from Croatia and i would like to know does anyone do pictures by drilling holes to get a raster picture. What is the proces and how to you make the g code. Because i tried to make one but i  hade to do it all by hand.

3

General Mach Discussion / Reboot whenever I open Mach3????

« on: February 10, 2019, 12:29:19 AM »

Hi Everyone. I have a fresh installation of Windows 7 Ultimate, 32 bit. The computer has MS Office 360 and Mach3 installed. It runs fine unless I open Mach3. If I open Mach3 it instantly reboots. I read elsewhere that there were compatibility issues with KB4088875; it is not installed. The hot processor/corrupt drive scenarios discussed elsewhere seem unlikely because the system runs fine for days and then reboots if I try to open Mach3. Any suggestions or guidance would be appreciated.