Messages

1

General Mach Discussion / Re: DQ542MA

« on: February 13, 2019, 05:46:49 AM »

Dont know what to do anymore. At the point to mayne rebuilt with Arduino and use a diffrent platform than Mach3

2

General Mach Discussion / Re: DQ542MA

« on: February 13, 2019, 02:10:27 AM »

Hi.

I have read that it can mayne have something to do with the ACPI drivers ?

3

General Mach Discussion / Re: DQ542MA

« on: February 11, 2019, 02:27:24 PM »

Current is still the same. If i make it less the motor wont turn at all

4

General Mach Discussion / Re: DQ542MA

« on: February 11, 2019, 01:37:59 PM »

I have changed the DQ542MA to 800pulses

Its a nema 23. 1.8° 200steps

5

General Mach Discussion / Re: DQ542MA

« on: February 11, 2019, 01:09:57 PM »

1Off
2On
3On
4Off
5On
6Off

6

General Mach Discussion / Re: DQ542MA

« on: February 11, 2019, 12:46:47 PM »

I have tried that and also with all the wires transferred to other driver

7

General Mach Discussion / Re: DQ542MA

« on: February 11, 2019, 12:36:33 PM »

Doo it looks like i got the motor to run. But befor the motor starts to run it jumps into different directions and then its starts to run.

Any idea what this could be. I have changes the velocity and acceleration but nothing

8

General Mach Discussion / Re: DQ542MA

« on: February 11, 2019, 07:04:54 AM »

If I unplug the connection from the Y axcis and put it into the XAxis motor. The motor works

9

General Mach Discussion / Re: DQ542MA

« on: February 11, 2019, 06:45:21 AM »

It does exactly the same    

10

General Mach Discussion / Re: DQ542MA

« on: February 11, 2019, 06:11:38 AM »

The driver was connected to a Mach3 Parallel controller but I have changed this in the meantime to a usb controller.

The Y Axis is work perfect but on the old motor Driver but the X Axis with the new driver don't want to work.

If I plug the Y axis into the X The Motor also runs perfect so def not the motor