Hello Guest it is March 28, 2024, 11:29:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - seedhe

Pages: 1
1
Mach4 General Discussion / Re: Anyone use mach4 recently; version 2?
« on: January 30, 2019, 09:50:06 AM »
I need to finally decide on my control software. I don't really want to pay for Mach3 and learn it since it's basically discontinued at this point and I'd rather just learn Mach4 to begin with. I know there's been a lot of complaints with it but most I've come across are from 2015 or earlier.


Thank you so much
________________________________________________________________

2
Mach4 General Discussion / Anyone use mach4 recently; version 2?
« on: January 29, 2019, 04:30:30 AM »
I need to finally decide on my control software. I don't really want to pay for Mach3 and learn it since it's basically discontinued at this point and I'd rather just learn Mach4 to begin with. I know there's been a lot of complaints with it but most I've come across are from 2015 or earlier.


3
General Mach Discussion / Mach3 issue?
« on: January 29, 2019, 12:02:54 AM »
(Edit to add update ******) So I did some more testing and test cutting last night. At this point I think I have completely ruled out Mach 3 or any sort of software/g-code issues. I made a pattern that had a very long narrow t-bone fillet so that I could actually watch the DRO as the bit went into the t-bone fillet and come back out. I could see that the axis had no movement on the DRO but you can see that when the bit exits the fillet and fully engages the material there is drift present.


4
General Mach Discussion / Re: Mach3 software.
« on: January 28, 2019, 11:18:14 AM »
Is there a trial version of mach3 or a similar freeware package out there? I want to give it s go to see if it’s for me before committing the cash to it.


Thank you so much
____________________________________________________________-

5
General Mach Discussion / Mach3 software.
« on: January 28, 2019, 04:09:36 AM »
Is there a trial version of mach3 or a similar freeware package out there? I want to give it s go to see if it’s for me before committing the cash to it.


Pages: 1