Hello Guest it is May 07, 2021, 07:15:33 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - sagarm

Pages: 1
Thanks Craig. I am not familiar with programming on Mach4. Are you tying to say that it can be done by modifying the script ? And how do i access these API's ?
Really appreciate your input!

Mach4 General Discussion / Can OB1 and OB2 be used inside the G-code ?
« on: January 27, 2019, 03:45:16 PM »
I am trying to control 8 stepper motors (simultaneously and independently) for custom application (non-CNC based). Since the software does provide an option to map motor 6 and motor 7 to OB1 and OB2, I was wondering if there is any way in which I can give OB1 and OB2 position values in the g-code. I am using a Pokeys57CNC controller which allows the use of up to 8 motors. really appreciate any help/suggestion/tips :)

Pages: 1