1
General Mach Discussion / Re: z height and machine 'parking" - mach3
« on: January 28, 2019, 05:05:09 AM »
it's set up that way. everything works as it should. i'm just trying to find out if there is a setting to have the tool offset from zero when it goes home. similar to safe z where it lifts to a safe height then travels. instead of lowering back down when it gets to its home, it just stays at that (safe) height. I don't recall which one i have it set to right now, but i did try them all and didn't do what i am looking for.