Hello Guest it is August 11, 2020, 03:12:06 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ironman123

Pages: 1
1
General Mach Discussion / Re: search function
« on: January 04, 2019, 12:52:57 PM »
Still no search function.  >:( >:( ??? ???

2
General Mach Discussion / HAPPY NEW YEAR 2019
« on: December 31, 2018, 05:18:28 PM »
Just want to wish you all a safe and Happy New Year 2019.

3
General Mach Discussion / Re: Mach3 and UC100
« on: December 30, 2018, 05:24:39 PM »
Hey Craig I am with you that Mach4 is better than Mach3.  I have trial versions of both.  I only used the Mach4 a couple of times.  I built little steam engines and used Mach3 to cut out the connecting rods from 1/8th inch thick aluminum and a few other goodies..

4
General Mach Discussion / Re: Mach3 and UC100
« on: December 30, 2018, 02:39:15 PM »
I planned on getting the UC100 from cnc4pc.  I appreciate your reply and the good information you gave.  The ethernet connection with UC300 sounds interesting also.  I also plan on using an optical isolator board for protection.  I will look at CNC Drive to.

5
General Mach Discussion / Mach3 and UC100
« on: December 30, 2018, 01:30:02 PM »
I have an older Xylotex 4 axis controller board on my milling machine.  It has LPT DB25 port I used with my older notebook which bit the dust (the notebook).  My newer notebook has USB ports and Jeff at Xylotex recommended UC100 or the smoothstepper to go from LPT DB25 to USB port.  I am wanting to use the UC100 with Mach3.  Are there any known problems with external pulse generation?

Thank you in advance,  Ray

Pages: 1