Hello Guest it is June 18, 2019, 09:30:02 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - cbocca

Pages: 1
1
General Mach Discussion / Re: G Code incomplete
« on: December 28, 2018, 12:53:56 PM »
Wow, I didn't realize it was the demo. It was included with my CNC and I thought it was legit since I bought it new.
Thank you so much!

2
General Mach Discussion / G Code incomplete
« on: December 27, 2018, 10:36:10 PM »
Hi, I'm new here and new to CNC as well. I have a 4x8 Industrial CNC and Mach3. It was suppose to come with BobCad-CAM but I was never able to set it up. A friend of mine suggested Enroute 4and that's what I installed (Windows 10). It basically works well until I have many shapes. I create the G code but then Mach3 only loads a portion of the code and not all the shapes. So far all of my shapes are just to cut. Am I doing something wrong? or the softwares are not compatible? Please help!

3
Hi, I'm new here and new to CNC as well. I have a 4x8 Industrial CNC and Mach3. It was suppose to come with BobCad-CAM but I was never able to set it up. A friend of mine suggested Enroute 4and that's what I installed (Windows 10). It basically works well until I have many shapes. I create the G code but then Mach3 only loads a portion of the code and not all the shapes. Am I doing something wrong? or the softwares are not compatible? Please help!

Pages: 1