Hello Guest it is March 28, 2024, 10:50:03 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - bpcnc

Pages: 1
1
General Mach Discussion / Re: Steps per unit strange trouble
« on: December 26, 2018, 09:32:55 AM »
I just discovered that my machine is acting in the same strange way.  >:(  I haven't been jusing the machine lately because I had a cable issue. Now, having replaced some cabling, I discovered that the traveling distance is totaly wrong. I want the machine to travel 1000mm on the Y-axis, but it moved much to far, so I adjusted the steps per unit. tested it some times and adjsuted the X-axis as well. Now I want the y-axis (only) to travel 250, 500 and 750 mm. but instead the machine moved about 260, 519, 758 mm (no exact meassurements). but traveling back to zero is no problem at all. I (tried to) check every possible adjustments and even went back to the original settings, but nothing seems to solve the problem.  ???

@ludara: did you solve your problem. keen to know what this strange behavior is comming from.

Pages: 1