Messages

1

General Mach Discussion / Command stopped due to buffer error...

« on: December 25, 2018, 01:34:59 PM »

Normally I'm a searcher, but since we can't I need some help.  I haven't had the router hooked up in 2 years and my old computer died that I was using on it.  I downloaded Mach3 and swapped over the license to new computer and added the UC-100 plugin and drivers.  Now when the Mach3 screen boots the reset button is flashing and will not reset.  The history shows command stopped due to buffer error.  I loaded it on 2 different computers with same result.  Any idea what's going on?  My specs are in my signature.  Thanks, and hope everyone is having a good Christmas.