Hello Guest it is March 29, 2024, 11:44:44 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - depronman

Pages: 1
1
PoKeys / mach3 and pokeys 57cnc - does it support threading ?
« on: September 02, 2019, 05:51:39 PM »
Hi all,
New on here
Done a Boxford CUD to CNC conversion, using a Pokeys 57CNC
got everything working including spindle speed / start / stop

cannot get the spindle speed readout to work in Mach3
using a proximity sensor that is feeding an external RPM readout with a single magnet pickup

any idea where I am going wrong ??

Cheers,
Paul

Pages: 1