4
« on: March 12, 2019, 05:24:52 AM »
Hi, friends
I have a problem with homing.
Usually when I press "ALL HOME", it first go home z axis then X and Y.
When the x axis hits the switch at end of movement, then the ax gets backwards few .mm, and then slowly to hit the switch again (for better precision, I suppose).
My problem is ...sometimes when the axe going back - not going far enough and do not release activated homing switch, and machine stop with message (emergency stop active-endstop)!
- I use the same switch for homing and endstops
So where to control how many steps or .mm axe going back before going to precise hiting the switch?
lp, chris