Hello Guest it is March 28, 2024, 09:51:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ciarancub83

Pages: 1
1
General Mach Discussion / Re: MDI Screen
« on: December 15, 2018, 02:32:38 PM »
Got it.. It's working now. Thanks.
Now  it goes to the actual coordinates whereas before hand if the spindle was at x50 for example and I input x10 it would move to x60 ( relative to the current position) I'm guessing I need to input a different G## value. Do you know which one it would be?

Thanks again

2
General Mach Discussion / Re: MDI Screen
« on: December 15, 2018, 11:00:00 AM »
Tried go x500 but nothing happened.

3
General Mach Discussion / MDI Screen
« on: December 15, 2018, 10:13:45 AM »
Hi. I am trying to square up my machines x axis with y axis.
I am on the MDI screen and I  input x500 for example and press enter.
The x axis starts to move but extremely slow. You can hear each step from the motor.
It was working fine last night in this mode unless I have clicked on something to slow it right down.??
Hope someone can help identify and resolve this issue.

Pages: 1