Hello Guest it is March 28, 2024, 05:48:08 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Flowerpot

Pages: 1
1
General Mach Discussion / Re: loss of Estop and limt swich signals
« on: December 23, 2018, 12:08:34 AM »
Same thing with 2 different cards? Has the external power supply for the inputs died or become disconnected? (I think it's the 24v and dcm connections, not sure though)

2
I agree, I'm currently rebuilding a cnc mill and deciding what control hardware and software to use. I was recommended Mach 4 and had a bit of a play with it and Mach3.  BUT the website is full of dead links and the support forum has been broken for over a month.  Not exactly confidence inspiring that a software company can't configure software.  ???

Pages: 1