Hello Guest it is March 29, 2024, 12:56:28 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - meshacnc1

Pages: 1
1
General Mach Discussion / Re: JogOn - Question/Problem - Macros
« on: December 01, 2018, 01:23:01 PM »
Yup that looks like it will work for what I want. Thank you

2
General Mach Discussion / Re: JogOn - Question/Problem - Macros
« on: December 01, 2018, 12:07:37 PM »
Thank you TPS. I want to create a probe that finds the top of an object. Then skims the top of said object until it falls off (releasing the switch), this would start at the same point and run twice in both directions. I could then calculate the center and set it to zero. I have created a probe that allows the the switch to release when the object it is riding on top of drops in initial probed height.

Hope that kind of makes sense.

Thank you

3
General Mach Discussion / JogOn - Question/Problem - Macros
« on: December 01, 2018, 11:33:04 AM »
I was hoping to add a custom switch that would stop a JogOn() within a give M code. I have made the macro as per the documentation but have found that JogOn(2,0), does not move the machine in the Z axis in the positive direction when place inside a M call.

Am I going about this in the right way?
Do I need to something extra to allow this function?

Thank you

Pages: 1