Messages

1

General Mach Discussion / Re: Why does it follow different tool paths from G code preview?

« on: November 29, 2018, 06:27:02 PM »

garyhlucas and Tweakie.CNC thank you very much for your early advice.
I will check with a more simple code.
Then, without believing the code automatically generated by Fusion 360, I will try to understand the code a little more and try upgrading the MACH 3.

However, sometimes it worked well when tested with the same code, is this also a common bug phenomenon?

2

General Mach Discussion / Why does it follow different tool paths from G code preview?

« on: November 28, 2018, 02:33:17 PM »

offline test. MACH3 3.041
Which setting is wrong?
It operates a different tool path than the preview of G code created with Fusion 360, and the cutter penetrates the base.
The yellow line is rambling. sometimes it may have worked correctly, it may not be completely misconfigured.
But drill hole opens on my table.
https://youtu.be/6Ai3uaDajLg
thanks