Hello Guest it is March 28, 2024, 06:44:48 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Stevef

Pages: 1
1
General Mach Discussion / What Resolution
« on: May 29, 2006, 08:24:27 AM »
Hi folks,
          I am currently building a small mill for model making. Was wondering what sort of resolution is required. I have motors and drivers that Half-step, and ball screws with a 20mm pitch (hey they were free). This gives me a minimum step of 0.05 mm, so I am going to gear it down. Obviously there is a trade-off between speed and resolution. Any thoughts would be gratefully accepted as I am quite new to this stuff.
                                     Thanks
                                             Steve

Pages: 1