1
Mach4 General Discussion / Re: stop or hold program correctly
« on: January 23, 2020, 04:06:53 AM »
Thanks for the answer.
So Feedhold is the only way to stop the program without losing steps or mispositioning. Even if the tool does not stop exactly in every case.
The decision as to whether a feed stop is enough or a stop must be very quick. That’s a problem. Was that also the case with Mach3?
Reinhard
So Feedhold is the only way to stop the program without losing steps or mispositioning. Even if the tool does not stop exactly in every case.
The decision as to whether a feed stop is enough or a stop must be very quick. That’s a problem. Was that also the case with Mach3?
Reinhard