Hello Guest it is March 28, 2024, 08:01:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - brian42120

Pages: 1 2 »
1
FAQs / Re: Setting Mach 3 Port to PCI parallel port address
« on: December 02, 2018, 09:41:28 PM »
Well, just a quick update... it’s been over a week now since I last heard from HXC, they asked for some setup information, I sent it but no reply yet, I may just ask for money back and get something different...I will update again soon...

2
FAQs / Re: Setting Mach 3 Port to PCI parallel port address
« on: November 22, 2018, 05:46:17 AM »
I would have to do something like that if everything else fails...
I heard back from XHC, they told me to tick off A-axis in ports and pins

3
FAQs / Re: Setting Mach 3 Port to PCI parallel port address
« on: November 21, 2018, 07:38:33 PM »
I’m not shame to admit Craig, that clearly describe me at this point

4
FAQs / Re: Setting Mach 3 Port to PCI parallel port address
« on: November 21, 2018, 04:03:56 PM »
I’m still waiting for XHC to reply, it’s probably going to be a few days...., but I think it’s a scrip modification this controller needs... to have the controller do the same to A & Y axis simultaneously...




5
FAQs / Re: Setting Mach 3 Port to PCI parallel port address
« on: November 21, 2018, 08:25:13 AM »
You are right Craig, I never did like the Chinese stuff whether it’s cheap or expensive, just don’t trust the quality...

Quality & Chinese just don’t mix well...!

I wrote to XHC to see if they have a fix, waiting on reply, will update soon again...


6
FAQs / Re: Setting Mach 3 Port to PCI parallel port address
« on: November 21, 2018, 06:11:47 AM »
Well TPS, since you brought that up, I will swap out that controller with another one I have (not XHC) and see what happens, this will remove the guesswork from the equation...

7
FAQs / Re: Setting Mach 3 Port to PCI parallel port address
« on: November 21, 2018, 04:50:40 AM »
I’m starting to think that way as well cause no matter what I do the slave axis just won’t move on homing...

8
FAQs / Re: Setting Mach 3 Port to PCI parallel port address
« on: November 21, 2018, 04:43:04 AM »
Thanks TPS, I’m not the only one in this situation I see...

9
FAQs / Re: Setting Mach 3 Port to PCI parallel port address
« on: November 20, 2018, 06:18:53 PM »
I do have a manual which I went over many times. However, it’s written in chinglish but I don’t recall reading anything about the controller settings for slaving, maybe ports? I will take another look at it seen that you brought that up, I maybe overlooking something, I will update what I find in a few hrs...
Thanks Craig

10
FAQs / Re: Setting Mach 3 Port to PCI parallel port address
« on: November 20, 2018, 05:04:49 PM »
Yes Craig it s made by XHC

Pages: 1 2 »