Hello Guest it is December 04, 2021, 03:59:13 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Vet Nick

Pages: 1
1
Hi All I'm Vet Nick I am not an engineer or anything like that but I've always been good with my hands. Back in Feb 2011, I was struck down with a heart attack at the age of 58 so a triple bypass and another 10 heart attacks later here I am still tinkering in my garden shed. Now for 7 years, I have had a bad brain fog caused by my medications. but in that time I have bought the raw materials and made my own CNC machine which measures 2000mm x 1000mm. all the time it was difficult because I was not able to use my memory which was none existent still I persevered and 18 months later I produced a new working machine. Mach3 I was told to use and I like it. I wish the same could be said for Auto Desk Fusion 360. due to my lack of brain power, I am still trying to learn it today but hey I'm getting there. Autodesk 360 is a very good program and I've enjoyed the challenge.

Now a little problem that I have is that I can't seem to enlarge the Mach3 display to fit the screen. If someone could help with this in a simple way it would be much appreciated.

Again help would be appreciated with a nil-low cost program that will allow me to crave photos to wood.  I thank you for your time reading this and look forward to any help that is received.

Pages: 1