Messages

1

General Mach Discussion / Re: HELP!! MACH3

« on: November 20, 2018, 02:04:36 AM »

Hi TPS,

Our unit is currently set in inches. Thank you for your suggestions. Will study more on the handling of the post processor and stuff.  Will give an update.  Thank you again and God bless.

2

General Mach Discussion / Re: HELP!! MACH3

« on: November 19, 2018, 08:39:37 PM »

Hi TPS,

Here's the gcode file. 

3

General Mach Discussion / Re: HELP!! MACH3

« on: November 19, 2018, 07:49:05 AM »

Oh ok. Sorry about that. Ok will send it. Thank you again

4

General Mach Discussion / Re: HELP!! MACH3

« on: November 19, 2018, 04:02:22 AM »

Thank you so much for your reply TPS. Im aorry about this, but where do i look for the GCode?

5

General Mach Discussion / HELP!! MACH3

« on: November 19, 2018, 02:08:19 AM »

Hi,

Im new here and im not sure if I am posting this question in the right forum page.  With regards to my problem, I don't know what happened but whenever I open a file that I would be engraving, the image would be away from the limit of the table of our machine. I am using a Precix 9000 router with mach 3 software. im attaching some pictures of the problem that I am encountering.  I do hope someone can help me