Hello Guest it is November 29, 2020, 12:26:47 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - BoardBumpers

Pages: 1
General Mach Discussion / Re: WHY DOES THR SEARCH NOT WORK?
« on: November 27, 2018, 05:19:38 AM »
Aww that sucks. I have an issue finding correct drivers for my XHC WHB04B-6 Pendant to get it working. The manufacturer lists drivers but they don't work at all. Any advice on where to look in the forum to find info regarding these XHC pendants?

General Mach Discussion / WHY DOES THR SEARCH NOT WORK?
« on: November 27, 2018, 04:55:32 AM »
Sorry for this post guys but I am very annoyed at the fact the search function on this forum does not work. Am I the only one experiencing this problem? I have tried on 4 different computers with no luck.

WTF?  ???

General Mach Discussion / Re: XHC WHB04B-6 Pendant unresponsive?
« on: November 18, 2018, 09:05:32 PM »
Not to sure. Still waiting on a response. I'll be sending it back here in a day or so if I don't get a response.

General Mach Discussion / XHC WHB04B-6 Pendant unresponsive?
« on: November 16, 2018, 06:51:22 AM »
Hi everyone,

I just got a pendant for my CNC but after installing the DLL file and setting everything up I'm Mach3 bassed off the supplied manual and any info I can find online, I have had no luck getting the pendant to work. Unless there is some magic button or setting I am at a realisation that the pendant is faulty as everyone who has shown the setup of this type of wireless pendant it looks to just work after the basic installation and setup. All buttons and wheel are unresponsive. The pendant shows its sending signals from its screen. I get no position values on the screen.

Has anyone else had this kind of issue? Should it just do the basic functions like moving the CNC when installed? As this is how it looks to work with others.

Any advice would be greatly appreciated as I'll need to return the unit.


Pages: 1