Hello Guest it is March 28, 2024, 04:24:57 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - timmycnc

Pages: 1
1
NC Pod / Re: Probe function with NCpod
« on: August 18, 2008, 02:50:14 PM »
I  have installed my zero plate on the Ncpod + mach3, but it doesn't work.

is this only with my setup, or is this a firmware bug ?


2
Mach3 and G-Rex / Mach3 + G100 + other Plc devices
« on: August 03, 2007, 12:19:49 PM »
Hello, ;)

a question :-\

is it possible if jou already connected a G100 to mach3,

to instal other Plc devices on the same setup. ( I want more possibilities)
and a other question:

is it possible if jou already connected a G100 to mach3 + modiO board,

to install  another Plc devices on the same setup.

This question i ask, because I want buy a G100 and to extend my machine with a Plc such as a siemens S7-200/ S7-300


Pages: 1