Hello Guest it is July 10, 2020, 07:29:38 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - judah

Pages: 1 2 3
1
LazyCam (Beta) / Re: lazycam
« on: May 30, 2007, 09:57:59 PM »
is lazy cam pro on sell now and is the turn portion working?

2
General Mach Discussion / digitiseing
« on: November 28, 2006, 10:20:10 PM »
after you have digitised your part how do you get mach to cut that part

3
LazyCam (Beta) / mach turn and lazy cam
« on: November 23, 2006, 05:17:00 PM »
can lazy cam be used with machturn?

4
General Mach Discussion / Re: mach turn od arc wizard
« on: November 23, 2006, 03:55:05 PM »
ya see it  will let you enter  a neg number  in z end mine will not and your and also in your z center
                                               thanks for the help though any more ideas would also be appreciated.
I'm currently running Mach mill would this affect any thing?


5
General Mach Discussion / Re: mach turn od arc wizard
« on: November 20, 2006, 03:54:29 PM »
mine will not let me cnange to a neg number its allways pos

6
General Mach Discussion / mach turn od arc wizard
« on: November 20, 2006, 01:56:45 PM »
hey dose any one know if the z end should be a neg number on mine there are no neg Numbers at all on the screen shouldn't there be?
 thanks

7
General Mach Discussion / mid ban res
« on: September 25, 2006, 10:29:48 AM »
can any one tell me what this is and how to tell if you are haveing troubel with it

8
General Mach Discussion / Re: max nc 10 wave drive
« on: September 24, 2006, 04:42:50 PM »
thanks brian so i shouldnt have to have max nc cheacked?

9
General Mach Discussion / Re: max nc 10 wave drive
« on: September 21, 2006, 11:06:46 AM »
 Iam useing a campbell breakout board. all the ports and pins are set up as they suggest downstream of the break out board
 are 3 gecko 210s running a size 34 stepper each all powered by a 40 volt  7 amp reg power supply.
 say im trying to cut a 2d 1by1 square the machine will move on the rapids put not the cut it self and unless i have max nc10 wave checked nothing will work at all. allso when trying to calb axise it ask for a dis  i enter one and it never moves.

10
General Mach Discussion / max nc 10 wave drive
« on: September 19, 2006, 11:14:23 AM »
Can any one tell me what this is ?
Im useing gecko 210 and get no movement unless this is checked.
is this normal?
also when trying to cal my axise nothing happens already up to 24.000 pulses per unit?

Pages: 1 2 3