Hello Guest it is March 28, 2024, 08:15:14 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - waynep

Pages: 1
1
General Mach Discussion / Re: Wrong sizes
« on: December 05, 2019, 12:45:28 PM »
Thanks for the quick response. The leadscrews are coupled to nema 23 motors and they are 2 start. I have no idea what microstep regime is?

2
General Mach Discussion / Wrong sizes
« on: December 05, 2019, 12:33:44 PM »
I just completed setting up a new cnc machine it uses a tp8x8 p2 leadscrews. I configured Mach3 and ran a sample. Everything functioned except sample was a 1x1" block .625 deep. It measures 1.25 x 1.25 . Where did I go wrong?

3
Howdy, Wayne P. here. 71 yr old retired and thinking of building a cnc router. I do pyrography and a little scroll sawing. Stay in north Carolina.

totally confused about the computer issue. Mach3 says non integrated video card and no laptop, but see a lot of laptops on videos running it and having a hard time finding a non integrated computer. Any help / direction is appreciated.

Pages: 1