Guest
Show Posts
1
General Mach Discussion / Mach3 Torch Height Control with Hypertherm 45xp
« on: September 20, 2018, 04:20:15 PM »
Hello all.
I've recently updated my plasma power source to a Hypertherm Powermax45xp. Is there a tutorial on how to integrate this machine into Mach3 without an auxilliary THC? With it's on-board voltage divider and other I/O I figured it would be a simple task but I cannot find much about it.
Ideally I'd use a probe function to touch the plate, reset Z, pierce and then use torch voltage to control the height.
Is this possible?
Thanks, Cole
I've recently updated my plasma power source to a Hypertherm Powermax45xp. Is there a tutorial on how to integrate this machine into Mach3 without an auxilliary THC? With it's on-board voltage divider and other I/O I figured it would be a simple task but I cannot find much about it.
Ideally I'd use a probe function to touch the plate, reset Z, pierce and then use torch voltage to control the height.
Is this possible?
Thanks, Cole