Guest
Show Posts
1
General Mach Discussion / Mach3 input triggered jump next line of g coce
« on: September 08, 2018, 02:54:32 AM »
Greetings to everyone!
Is it possible use physical limit switch to stop axis movement and after input triggered g code jumps to next line?
I have steelsheet nesting machine under construction.servomotor powered axis move steel sheet in horizontal line and vertical z axis hydraulic cylinder press punch tool to do made holes for steel sheet.
I turn z axis step/dir signal to +-10V signal using external card and this give command hydraulic propotional servo valve.
I think so this case z axis not move linear,depending hole diameter and material hardness/tights it need different hydraulic pressure/time to punch hole in sheet.
In my mind this z axis movement not need be so accurary to use anykind position encoder,some types limit switch would be practical to control hydraulic cylinder movement.
Is any way to get program jumps next line of g code after input triggering...
-Mika-
Is it possible use physical limit switch to stop axis movement and after input triggered g code jumps to next line?
I have steelsheet nesting machine under construction.servomotor powered axis move steel sheet in horizontal line and vertical z axis hydraulic cylinder press punch tool to do made holes for steel sheet.
I turn z axis step/dir signal to +-10V signal using external card and this give command hydraulic propotional servo valve.
I think so this case z axis not move linear,depending hole diameter and material hardness/tights it need different hydraulic pressure/time to punch hole in sheet.
In my mind this z axis movement not need be so accurary to use anykind position encoder,some types limit switch would be practical to control hydraulic cylinder movement.
Is any way to get program jumps next line of g code after input triggering...
-Mika-