Messages

1

CS-Lab / Re: CSMIO-ENC Spindle Orientation

« on: July 26, 2019, 09:58:58 AM »

I see that you have KVff set to 0, from my experience it's role is very important.
Did you play with it (values can be like 30 but 200something isn't uncommon)?
Also, when spindle RPM is 0, is it really 0? And what's the position error?
Is the offset voltage properly set? Spindle RPM 0 and clicking the arrow does change anything?

2

CS-Lab / Re: CSMIO-ENC Spindle Orientation

« on: July 26, 2019, 09:50:29 AM »

When you run your spindle at 10% and 80% of maximum speed, what is the current position error and maximum error?
Did you modify in any way M20 macro?

3

CS-Lab / Re: CSMIO-ENC Spindle Orientation

« on: July 26, 2019, 09:39:33 AM »

My spindle is controlled by 0-10V signal (analog output)

4

CS-Lab / Re: CSMIO-ENC Spindle Orientation

« on: July 25, 2019, 04:53:05 PM »

Those screens I'd like to see.

5

CS-Lab / Re: CSMIO-ENC Spindle Orientation

« on: July 25, 2019, 04:41:31 AM »

Could you post screenshots of your configuration?
To which channel in the ENC module you have the encoder connected? (pic perhaps?)

6

CS-Lab / Re: CSMIO-ENC Spindle Orientation

« on: July 24, 2019, 06:12:17 PM »

Are you also sure of the number of pulses per rev? (all edges counted)?

7

CS-Lab / Re: CSMIO-ENC Spindle Orientation

« on: July 24, 2019, 11:49:38 AM »

Did you tune PID in the spindle setup?

8

CS-Lab / Re: CSMIO-ENC Spindle Orientation

« on: July 24, 2019, 08:25:25 AM »

When it's connected and you try M20 Q140, what sort of error do you receive?

9

CS-Lab / Re: CSMIO-ENC Spindle Orientation

« on: July 24, 2019, 06:23:05 AM »

Threading didn't work when you pulled out the index signal from ENC and IP-A?

10

CS-Lab / Re: CSMIO-ENC Spindle Orientation

« on: July 23, 2019, 07:56:45 AM »

Could you disconnect the index signal from controller and enc module and check whether threading  still works?