1
General Mach Discussion / Re: Convert to Mach3 from DeskCNC
« on: August 29, 2018, 08:54:16 AM »
Hi,
New here...just to reaffirm the fewcomments regarding this subject here and elsewhere. I have a Sys3A and wanted to switched and use Mach3 but you need to change the control board. I wished I would know this a couple years ago. IMService does not provide any help and hitted the can elsewhere...They sure took my money a couple years ago!
Alexg
New here...just to reaffirm the fewcomments regarding this subject here and elsewhere. I have a Sys3A and wanted to switched and use Mach3 but you need to change the control board. I wished I would know this a couple years ago. IMService does not provide any help and hitted the can elsewhere...They sure took my money a couple years ago!
Alexg