Hello Guest it is March 28, 2024, 01:27:09 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - TroxKor

Pages: 1
1
General Mach Discussion / Re: Mach3 pin 15 Always active
« on: August 01, 2018, 01:03:42 AM »
Yea, I changed all of the setting to see what would happen, it would either move to always triggered or never triggered. I changed it from the probe to a limit switch that was working fine. Same results. I changed the break out board, same results. Really at a loss. I can work around it by doubling up a limit switch, just not ideal.

2
General Mach Discussion / Mach3 pin 15 Always active
« on: July 31, 2018, 03:45:30 AM »
I tried a few searches so as to not double up posts but didn't find a post that helped.

Recently bought a X2 converted to CNC from a guy that has used it for years. I need a probe in my machine, and this is where my trouble starts. Pin 15 is always showing as triggered. I changed cables, break out boards, switches, all of it but PC components.

Anyone have an idea what might be the cause? Do I need to get a whole new PC?

Pages: 1