Hello Guest it is March 28, 2024, 02:52:21 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Cos_phi

Pages: 1
1
General Mach Discussion / Set Output when homing
« on: July 10, 2018, 04:50:33 PM »
Hello!

I am new in this Forum.
I have build an 3 axis Portal milling with Mach3 Software and a Beckhoff PLC. The PLC is connected with all limit, reference and emergency switches and disable and enable the drives. My negative limit switch is also my reference switch. So the PLC has to know when the machine is homing. The easiest way would be to set an Output when the machine is homing.

Is there a way to realize this???

with best regs :)

cos_phi

Pages: 1