Hello Guest it is March 28, 2024, 04:49:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - glukkon

Pages: 1
1
Hello all I am very new, this is the first time trying to learn this stuff. I have been reading manuals and watching videos trying to get things setup but I am finding it very hard to put all the pieces together. I bought a used CNC Mogul and I am using Mach4 with a UC100 controller. Does anyone know where a good place is to find a guide to help me walk through the process. I have the machine to the point to where I can jog but I have not calibrated, homed or set limits, etc. Any help would be great, like I say I am a total newbie and have learned a lot over the past few weeks but considering most of the information I am finding tells how to do one task or the other. I am not even sure which order I need to go in to setup the machine. Any help would be greatly appreciated. Oh, just in case it helps I am not trying to do anything extreme, I just need to learn to make wooden signs.

Pages: 1