Messages

1

General Mach Discussion / Re: usual hard drive swap problems.

« on: July 11, 2018, 05:13:36 PM »

Well, CNC nuts, episode 104, and it all seems to be working..
just knowing you guys are there helps.
thanks.
cnc jim

2

General Mach Discussion / usual hard drive swap problems.

« on: July 11, 2018, 02:38:25 PM »

So the hard drive failed but I got the Mach 3 folder copied onto a thumb drive.
With new hard drive installed I copied the folder on the desk top and clicked on the shortcut. All seemed to load as normal, but although the DRO's move the motors don't.
I am on XP pro, I have recent .xmls, I guess it's something simple, but what?
thanks in advance guys..
always panic when this happens, but it's been 4 years so...
i have of course searched the forum