Hello Guest it is December 07, 2021, 09:50:14 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - BigKahunaFL

Pages: 1
1
Hi gang!

As the saying goes, "When life hands you lemons, make lemonade".  In my case, life handed me a sack of lemons and all I got was an eye full of citric acid!  ;D  Got laid off from my full-time job thanks to outsourcing, or as the company calls it, "Right-Sizing".  ???

I'm an Engineering Designer by trade specializing in tooling, fixtures and jigs, etc. for manufacturing as well as production lines, R&D and pilot lines.  I've been doing this sort of work for the last 25 years or so.  I used to operate some of the earlier wire E.D.M. machines which used paper-punch tapes for the program.

I am now interested setting-up a small, table mount, gantry type, CNC engraver/mill for fabricating/detailing parts for my custom Corvette.  I also have small setups for powder-coating, anodizing and plating.  Holy cow!  With all this stuff, maybe I could start making some lemonade! ;)

2
FAQs / Re: System Requirements
« on: July 23, 2007, 10:11:14 AM »
BUMP.

I'm interested in this as well.

Anyone?

Pages: 1