Messages

1

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: August 18, 2018, 09:07:38 AM »

Gerry is the man!

With the new macro's the machine is working like it should.

Thanks a lot!

2

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: August 17, 2018, 09:26:33 AM »

no problem, thanks again

3

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: August 17, 2018, 09:13:33 AM »

The Email is send, thanks man!

4

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: August 17, 2018, 07:59:54 AM »

I had cp set to 1.0 but also tryed it with 28.0
My controller is a (chinees) stb4100 usb card. I looked at the code and it looks like the g0 z new+1 mm move is mistaken for machine coordinate z +1.0. Can i fix things using g91?

5

Finished Screens / Re: Mach3 2010 Screenset - Now available

« on: August 17, 2018, 05:54:16 AM »

Today I installed the 2010 screenset, I placed the macro's in the right folder and activated the brains. If I try to zero my tool the spindel moves down, stops on the plate and than retracts all the way to the Z axis limitswitch. The machine like's to go to a positive Z machine coordinate (and it can't).

I have set the change position in machine coordinates (X+135 Y+90 Z-15) Z-15 is 15mm below my home/limit position, soft limits are set to -2mm

The machine has no problems with the G31 command, If I use a 'simple' zero script it works like it should.

Anything I can do about that? I would realy like the tool change capability's of this screen.