Messages

1

General Mach Discussion / Re: Need help on homing machine

« on: May 31, 2018, 12:04:05 AM »

I believed it is also double as limit switches. I dont know about the wiring , this is a China CNC machine, switches are low active.

How can I set the pull of distance ? and where should I set it up ? can you guide me on this, I've been trying to contact the manufacturer  but to no avail.
I was being told that they will coordinate this with their engineer, I purchase  the cnc machine and comes with a pc and software needed.
Thank you for helping Craig.

2

General Mach Discussion / Need help on homing machine

« on: May 30, 2018, 12:07:52 AM »

Hi, this may sound stupid but I really need help,
Whenenver I press refer to home, it will home the z first and when it comes to x and y ,
when it touches the homing switch on Y it will back down, but unlike the Z axis it won't stop backing until it reach the end of the table , same thing will happen with the x axis
so in order for it to stop , I'm manually lighting up the switches by using a metal.
I can still use the machine , I'm not able to figure out how I can remedy this.
Thanks for any help.